 |
 |
 |
|
AQUAMATE CARPET SHAMPOO SYSTEM
NEW STYLE
EVENTUALLY !!!
Shampoo system to use with your Rainbow vacuum that will do all scrubbing and rubbing for you.
It has a rotating brush roll underneath the unit that scrubs the dirt of the carpet. Can be setup to clean hard surface floors.
Needs new design hose and stainless steel wand.
They are standard with later 2 speed Rainbow E2 cleaning systems but you may
have to buy them if you own 1 speed or early 2 speed Rainbow vacuum.
Stainless Steel Wand:
Cord plug on the Aquamate 3 is a bit wider than vacuuming nozzle cord plug and this is to ensure that you will not be able to use the shampooer with non-approved for water pickup electrified hose.
So hole in the appropriate for wet pickup electrified hose plastic handle is the shape that will accept this plug:
Included:
- Aquamate
- Printed Manual
- Sheet with hints on usage
- 1 qt. shampoo concentrate
Operation:
Setup and shampoo:
- Blue
water tank has 2 compartments - one for just tap water and another for
Aquamate shampoo diluted with water (only cool tap water should be
used). Fill up both.
- Start with Rainbow vacuum water basin
empty. For larger houses we recommend getting 4 quart water pan that
needs to be emptied less often.
- Use stainless steel power nozzle wand and new style electrified hose to connect Aqua Mate to the vacuum.
- Work on about 3 feet X 3 feet patches of carpet at a time.
There are 4 modes that Aquamate will operate in:
- Pedal lifted to the very TOP position. Hose trigger pressed - brush rotating - this will dispense soapy water and brush roll will work the solution into the rug.
- Pedal pressed half way down to MIDDLE position. Hose trigger pressed - brush rotating - this will dispense clean water to rinse the carpet and brush roll will continue scrubbing it.
- Pedal pressed all the way down to BOTTOM position. Hose trigger pressed - brush rotating - this will not dispense any liquid but brush roll will continue scrubbing the rug.
- Pedal pressed all the way down to BOTTOM position. Hose trigger released - brush is not rotating - now you can go over the area you have just shampooed and pick up the water.
- You can use those positions in the way you see fit. If you ended up spraying quite a bit of soapy solution you may want to go to position 4 before you rinse the rug (position 2)
- Move to the next patch of the carpet or rug.
Cleanup and Storage:
- It is important that you finish shampooing with RINSING phase.
- Dump the remaining liquid out of the blue plastic container and rinse with clean water.
- Disconnect the hose from long extension and use it to vacuum up any liquids left in the system itself.
- Lift the brush roll (you have to just pull it) to access the spray nozzle and vacuum it up too.
- Remove and clean the clear plastic and under it.
Disclaimer:
We are not affiliated with Rexair, Inc. - no factory warranty. This Rainbow vacuum motor unit is still covered under our guarantee.
|
|
|
|
|
|
|
|
| Accessories for this product... |
|
|
|
|
