Home > Rainbow > Parts > Rainbow E2 (black) series > Black E2 motor unit parts >

Rainbow Computer / Controller E2
Rainbow controller 120v E2


 
Our Price: $311.99



Product Code: R-PRT-R12528
Qty:

Description Russian
 

Rainbow computer/controller

Rexair circuit board for 2-speed E2 models

This is an electronic 2-speed Rainbow vacuum "brain" for 120 volt (US) unit. Also known as the electric or circuit board and computer that runs the two speed Rainbow vacuums.
This controller is for units with sound insulating foam inside.

This is an expensive part so before you buy it we would recommend sending the defective part (or even entire unit) to us so we can inspect it and make sure it is bad. (we will send it back to you). Make sure the motor bearings are good. Sometimes damaged bearings make unit vibrate to the point where vibration damages the controller. Installing ground your body to prevent damage to controller by ESD (Electro Static Discharge).

ONLY if we install it in our shop we guarantee the controller 1 year. No installation charge but you will be required to pay shipping.

Fits:
  • E2 Type 12 Black (Diamond)
  • E2 Two Speed
  • E2 Blue (Platinum / Silver)
  • E2 Gold Two Speed
Rexair Rainbow part (spares) catalog # R15395 (old part # R12528)

IF YOU DECIDED TO DO IT YOURSELF:
There are 2 controllers available today.
Electronics module in both is the same - only difference is the case. Older 2 speed Rainbow vacuums had controller case with a vent that came out in the rear of the unit and had a grill. New design ­ is the box that does not have an exhaust but rather is completely covered with acoustic home inside of the unit.

Replacing is fairly easy ­ no need to take a single screw out)
  1. Remove clear plastic panels
  2. Lift the unit about 1 inch from the floor
  3. Use flat screwdriver to press in the tabs that you will see once you remove the side panels
  4. It will release the cap from the main unit and unit will drop on the floor, this is why it is important not to lift it too high
  5. Disconnect all wires from old controller
  6. Pull controller off the motor holding it by one of the corners
  7. Pull another corner
  8. Eventually the controller will come off
  9. Position new part just like old controller was installed
  10. Press it down onto the motor ­ it will just snap into place
  11. Reconnect all wires as they were (it would be nearly impossible to connect them wrong)
  12. Press the cap onto the main housing till all 4 tabs will lock it onto the main body
  13. Install the labels and clear panels back

Disclaimer:
We are not affiliated with Rexair, Inc. - no factory warranty. This Rainbow part is still covered under our guarantee.
ONLY if we install it in our shop we guarantee the controller 1 year. No installation charge but you will be required to pay shipping.
Rexair Rainbow part (spares) catalog # R15395 (old part # R12528)



WARNING: This product can expose you to chemicals including Di (2-ethylhexyl) Phthalate (DEHP), which is known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

You may be interested
Rainbow Computer / Controller E2 220 volt
Our Price: $414.96

Add
Rainbow controller 220v E2

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Rainbow > Parts > Rainbow E2 (black) series > Black E2 motor unit parts
Rainbow > Parts > Rainbow E2 (blue) series > Blue E2 motor unit parts
Rainbow > Parts > Rainbow E2 (2 speed) series > E2 motor unit parts