Home > Other Brands > Oreck >

Replacement Oreck Motor AFT
Replacement Oreck Vacuum Cleaner Motor


 
Alternative Views:


Our Price: $27.99


Product Code: AFT-ORECKMOTOR
Discontinued by GoodVac

Description
 
Aftermarket Oreck vacuum motor will fit nearly all Upright Oreck vacuums
This is an aftermarket part

(Will work in USA, Canada and Mexico. But do NOT buy it if your country power supply is 220 / 230 or 240 volt. This is 120 volt motor) 60hz / 580W.

Will fit following models:
U2000E U3720HG U4140HH XL2700HH
U2000E2 U3720HR U4150H2P XL2700RH
U2000EB U3760HH U4150H2R XL2700RHY
U2000H U3761HH U4151H2G XL2800H2B
U2000H2 U3770HH U4160HH XL2800H2US
U2000HH U3771HH U4170HH XL2800H2W
U2000R U3772HHB U4180HHC XL2800HAY
U2000RB U3772HHG U4180HHT XL3505HH
U2000RSB U3772HHT U4200H2 XL3600HH
U2160HH U3773FL U4490HH XL3600RH
U2170HH U3773GA XL2000HH XL3605HH
U2200RD U3773LSU XL2000RH XL3610HH
U2250RS U3773OSU XL2000RS XL3640HH
U2251RS U3773TN XL2070RH XL36R7HH
U2310RD U3773TX XL2090RHM XL3800H2B
U2310RSF U3773TXAM XL2090RSM XL3900H2B
U2330RD U3780HH XL2100HH XL3910H2B
U2510RH U3785HHM XL2100RH XL5-105HH
U2520RH U3785HHT XL2100RS XL9000D
U2530RH U3795HHS XL2200RS XL9000W
U2540RH U3800HH XL2250RS XL9100C
U2630HHG U3980H2B XL2260RS XL9100HG
U2630HHR U3990H2B XL2300RS XL9200
U2640RH U4070H2L XL2310RS XL9300
U2650HHB U4080H2B XL2320RH XL9300C
U2650HHR U4080H2R XL2330HS XL9300G
U2650HHW U4080H2Y XL2330RS XL9300H
U2740RD U4090H2B XL2400RS XL9300MM
U3120HH U4090H2G XL2450RH XL9300MS
U3140HH U4090H2P XL2500HH XL9300S
U3620HH U4090H2T XL2500RH XL9800
U3640RH U4120H2B XL2540RH
U3700HH U4120H2P XL2600HH
U3710HH U4120H2R XL2610HH
It also may fit some models that are NOT on the list above.
Replaces Oreck spares catalog numbers: 097550501 or 0975505-01 or 09-75505-01

Average Customer Review: Average Customer Review: 4 of 5 4 of 5 Total Reviews: 2 Write a review.

  0 of 0 people found the following review helpful:
 
4 of 5 Can be made to fit XL9200 with some alterations. February 7, 2017
Reviewer: BR from OH  
I bought this part and installed it in an Oreck XL9200. After finishing, the sweeper body and handle would not pivot freely. After a thorough inspection I noticed the new motor mounts had a small round recess molded into them compared to the old mounts which were flat on the bottom. When tightened down, this caused the motor to bind the pivot point. Leave motor loose, pivot works, tighten down, pivot binds. I placed one small machine washer in each mount recess which aligned the pivot like the old motor and now the pivot works. Motor, vacuum, and pivot working fine now!  The pivot I referred to is the vacuum body to handle pivot. This centers around the motor shaft/vacuum fan centerline, so if the motor is too low(without washers) it binds the pivot and the handle/body binds so you can't tilt handle back to vacuum!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 Almost fits Oreck XL9800--need pads and shims August 26, 2015
Reviewer: JGK from Upstate NY  
If you ignore the motor orientation pictured in the diagram and concentrate on the electrical connectors relative positions you will be OK.  Note that the black wires going to the dual "headlights" are not interchangeable.  The shorter wire goes to the rearward connector; the longer closer to the headlights.

The OEM motor comes with stick-on foam-pads in line with the mounting ears.  They surround the motor and buffer it in its clamp like cradle.  Transfer the foam pads from the OEM motor to the replacement.

Without shims, when the motor ears are tightens down, the impeller housing severely binds with the main housing. The head will not sit flat on the floor.  Too much friction causes the head to lift or drag when pushed or pulled over the carpet.  Two small flat washers under  each motor ear were sufficient to center the impeller housing in its channel and permit appropriate movement of the main housing.

Overall: minor hassles offset by low price.

Was this review helpful to you?


Browse for more products in the same category as this item:

Other Brands > Oreck
Miscellaneous > LANDING > Shop By Manufacturer > GVC