Kirby slide with spring

FREE SHIPPING on orders over $100

View Details

Home > Kirby > Parts > Kirby Sentria parts > Headlight Cap/Pivot Spring Asm >

Kirby Slide With Spring

Our Price: $7.36

Product Code: K-PRT-HLCP-676595S

Qty:

Description

Russian

SLIDE WITH CENTERING SPRING ASSEMBLY
(fits all Kirby hoover models that have power-drive)
Fits Kirby Models:

Avalir 2
Avalir
Sentria II (G10D)
Sentria (G10)
Ultimate G Diamond Ed.(G7D or DE)
Ultimate G (G7 or UG)
Generation 6 (G6)
Generation 5 (G5)
Generation 4 (G4)
Generation 3 (G3)

Early Kirby slides (G3 and early G4) did not have the spring so Kirby vacuum was more likely to "get stuck" in gear. The spring brings the slide to the center when handle is released thus disengaging the tech drive and putting Kirby in "neutral".

If you can see that surface where bearing rollers touch the slide damaged - you have to replace it. If this is the case we would recommend replacing both bearings and slide guides too. Use a little bit of lithium grease to lubricate the bearings.

Guide Block

Roller Bearing

Kirby part number: 676595

WARNING: This product can expose you to chemicals including Di (2-ethylhexyl) Phthalate (DEHP), which is known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

	Kirby Rivet-Exhaust Horn Gasket $0.40
	Kirby Headlight Cap G5- DE $36.98
	Kirby HEPA PLUS Bag 6pk 204814 $26.42
	Kirby Rear Axle retainer RIGHT $0.33
	Kirby DE Cloth Bag ONLY $72.66
	Kirby Turbo Accessory $32.50
	Kirby On/Off Pedal G4 $5.68
	Kirby Exhaust Gasket $5.19
	Kirby Base G4/G6 $39.81