KIRBY VACUUM POWER SWITCH
This is for 110 volt vacuums (USA, Mexico, Japan and more...).
Will fit 220 volt version made for Europe, Australia and other 220 volt regions (read description on the bottom of this listing).

Part # 110590, AKA Kirby Safety Switch

This will fit all Kirby Generations vacuums starting from G3 all the way up to Avalir.

If you are not experienced vacuum repair expert but still would like to attempt replacing switch yourself - we suggest doing it at once so you will not forget how to put it back together. If you have a digital camera - snap plenty of pictures so you could look up how things are being put back together.

Few things to pay attention when installing the switch:
1. Before you dissemble - take a look where the both headlight are wires plugged in. One terminal (for the upper one) is so well hidden that have to note where it is before taking apart the Kirby.
2. Assembling you will have to know how to install slide bracket (see 2 last pictures on THIS PAGE in our Knowledge base).
Make sure the plastic gears and the primary drive belt (inside the vacuum) are clear of wires. Use cable ties.

For manual on How to replace Kirby switch go HERE

( 110590 )