Rexair part #R11138

Aquamate 2 Pump Housing LOWER

To remove it you will need to break 4 latches off (use pointy pliers) the upper housing.
Old upper housings can not be reused but new ones can so get one now HERE. If you will have to take apart the Aquamate 2 again - the first time you will need to break those latches again but then just drill 4 holes in lover housing in pre-marked locations and use 4 screws to hold them together. We would suggest getting the 4 screws now so you do not have to look for them later when you need them.

Aquamate 2 lower housing part #R11138

This lower housing will not accommodate old style tube fittings:
Aquamate 2 old tube fitting

So you need to purchase entire set of:
1. Upper housing
2. Lower housing
3. Male fitting and tubing assembly
4. Double female fitting

WARNING: This product can expose you to chemicals including Di (2-ethylhexyl) Phthalate (DEHP), which is known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Rainbow > Parts > Aquamate II

	Rainbow Front Label E2 series $4.11
	Rainbow Aquamate III tubing 1 pedal $18.30
	Aquamate 2 Pump Motor $43.79
	Rainbow E2 (black) Edge Brush - LONG $4.94
	Rainbow Aquamate III motor pump $94.98
	Rainbow E2 Upper Fan Spacer $6.29
	Original Rainbow Gasket D4/SE $10.35
	Rainbow Main Motor E Series $315.59
	Rainbow Hose Handle Cover Plate $2.82