Home > Kirby > Parts > Kirby G3 parts > Attachment Set (G3) >

Kirby G3/G4 Hose End Seal Gasket
G3/G4 Hose End Gasket
 
Our Price: $0.99


Free Shipping
Product Code: K-PRT-ATT-223881S
Qty:

Description
 
Kirby vacuum cleaner
SUCTION/BLOWER CONNECTOR GASKET / SEAL

Will work with following Kirby sweeper models:
  • Generation 3 (G3)
  • Generation 4 (G4)

To replace:
Most would find it easier to buy whole assembly. However if you have patience and time, you will need to remove as much of the old gasket as possible so you have clean grove in the plastic part. Then use glue to glue new strip in. We would recommend removing the plastic end from the hose first and after installing the new strip setting it on a flat surface the gasket facing down. Then putting just enough weight on the top so the gasket is retained inside but not pressed too much to get deformed. Leave it like this long enough for glue to cure completely.

Part #223881s

California lawyers like to sue for profit anyone who sells anything to state of California that contains one or more of 1000 chemicals known to California to cause cancer. We do not have chemist nor toxicologist on staff so we will just leave this warning below as pretty much anything known to the state of California causes cancer.

WARNING: Cancer and Reproductive Harm. For more information, go to www.P65Warnings.ca.gov

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Kirby > Parts > Kirby G3 parts > Attachment Set (G3)
Kirby > Parts > Kirby G4 parts > Attachment Set (G4)
Kirby > Parts > Popular Parts > Attachments > Kirby Attachment Hose


Kirby G3 Cloth Bag Only $98.32
Rainbow H597 Rotor Sensor Screw $2.04
Kirby Attachment Hose Sentria II $39.69
Kirby Generation After Generation Poster $10.40
Rainbow D3 Switch
Kirby Wand G3